Installation Manual for DiBos Video System
Connections (continued)
4.9Connecting the Software Dongle and the Printer
The programs are protected against unauthorized use by a dongle. The system cannot be operated without this dongle. The dongle must be con- nected to the PRN interface (LPT1) on the system board and remains there throughout operation. The dongle must be plugged in before switching the system on.
A printer must be connected via the USB interface so as not to hinder the reading out of program information from the dongle.
4.10Connecting a Fault Indicator
A fault indicator (sounder) can be connected to relay 4 of the 1st MVTitan grabber card (must be activated in the configuration under Hardware/ Connections).
The following events will be signaled by the fault indicator:
DImages may be lost because the alarm archive is full
DThe free disk space is not sufficient for the programmed total size of the archives
DThe camera is not transmitting a video signal
DThe database server could not record all images
DThe grabber process does not answer in the prescribed time (timeout)
DThe programmed holidays/special days are not released in the hard- lock
DThe programming for the
DSystem overload
DThe directory could not be deleted from the database server
DCannot create and write logbook
DThe images could not be recorded by the database server
DThe backup medium is full
DA timed backup could not be executed because a search macro was not found
DThe programmed number of grabbers does not match the actual hardware configuration
D5% of the hard disk is not free
DThe database server is not started
| – 32 – |
