74 Installing System Components
2Viewing the assembly as shown in
Figure 3-6, a
lign the bottom rear screw
hole on the hard drive with the hole labeled "SATAu" on the hard drive
carrier.
When aligned correctly, the rear of the interposer will be flush with the
rear of the hard-drive carrier.
3Attach the four screws to secure the hard drive to the hard-drive carrier.
See
Figure3-6.
4
Attach the interposer card to the rear of the SATA hard drive:
a
Angle the top of the interposer card into the inside top carrier rail so
that the tabs on the interposer card bracket attach to the slots on the
inside of the carrier rail.
See
Figure3-6.
b
Rotate the bottom end of the card toward the hard drive to seat the
connector.
See
Figure3-6.
c
Push the bottom end of the card to the hard drive until the latch on
the card bracket clicks into place.
Book.book Page 74 Monday, September 14, 2009 12:57 PM