Dell DL2000 owner manual Accessing System Features During Startup

•Operating system documentation describes how to install (if necessary), configure, and use the operating system software.

•Documentation for any components you purchased separately provides information to configure and install these options.

•Updates are sometimes included with the system to describe changes to the system, software, and/or documentation.

NOTE: Always check for updates on support.dell.com and read the updates first because they often supersede information in other documents.

•Release notes or readme files may be included to provide last-minute updates to the system or documentation or advanced technical reference material intended for experienced users or technicians.

Accessing System Features During Startup

Table 1-1 describes keystrokes that may be entered during startup to access system features. If your operating system begins to load before you enter the keystroke, allow the system to finish booting, and then restart your system and try again.

Table 1-1. Keystrokes for Accessing System Features

Keystroke	Description
<F2>	Enters the System Setup program. See "Using the System Setup
	Program" on page 46.
<F10>	Opens the utility partition, allowing you to run the system diagnostics.
	See "Running the System Diagnostics" on page 153
<Ctrl+E>	Enters the Baseboard Management Controller (BMC) Management
	Utility, which allows access to the system event log (SEL). See the
	BMC User’s Guide for more information on setup and use of BMC.
<Ctrl+C>	Enters the SAS Configuration Utility. See your SAS adapter User’s
	Guide for more information.
<Ctrl+R>	Enters the RAID configuration utility, which allows you to configure a
	RAID card. For more information, see the documentation for your
	RAID card.

12

About Your System