DFX-8500

ASSEMBLING POINT

z￿ Confirm that the cables are connected correctly. (Refer to Figures 3-12 and 5-3..)

z￿ Tighten the screws while pulling the printhead as shown below to secure the printhead firmly.

Figure 3-14. Printhead Installation

Step 12: Install the cable cover and the FPC cover.

Step 13: Wipe off any stains from the carriage guide shaft, lubricate both ends of the carriage guide shaft with the included oil (0-2), and spread the oil over the shaft by moving the carriage manually.

Figure 3-15. Lubricating to Carriage Guide Shafts

ADJUSTMENT REQUIRED

z￿ When you install the printhead, perform the platen gap motor value adjustment (ALPHA value write operation) described in Section 4.1.7).

3-12

Rev. B

Page 102
Image 102
Epson DFX-8500 service manual Adjustment Required