Epson DFX-8500 service manual Adjustment Required

DFX-8500

Step 5: Remove the four screws securing the printer mechanism to the lower case.

S c r e w s

S c r e w s

Figure 3-43. Printer Mechanism Removal 1/2

Step 6: Install the lift handles from the inside of the printer mechanism. Insert each handle through the two holes in the side frames of the printer mechanism. Then slowly lift up the printer mechanism using the handles and remove it from the lower case.

L if t H a n d le # E 6 5 6

P r in t e r M e c h a n is m

L o w e r H o u s in g A s s e m

Figure 3-44. Printer Mechanism Removal 2/2

ASSEMBLING POINT

When you install the printer mechanism, route the cables as shown in Figures 3-41 and 3-42. Make sure the cables do not get caught between the printer mechanism and lower case.

ADJUSTMENT REQUIRED

When you install the printer mechanism, perform the following adjustments:

￿Platen gap motor value (platen gap) adjustment (described in Section 4.1.7) Bidirectional printing adjustment (described in Section 4.1.8)

3-30 Rev. B