Epson DFX-8500 service manual Continuous Forms with Labels, Avery Continuous Form Labels

GENERAL DESCRIPTION

1.2.12.3 Continuous Forms with Labels

Table 1-7. Continuous Forms with Labels

			Front Entry				Rear Entry
			Minimum		Maximum		Minimum		Maximum
Label Size		Refer to Section 1.2.12.2.						-
Width	(inch)		4.0			16.0	-		-
	(mm)		101			406
Length	(inch)		4.0			17.0	-		-
	(mm)		101			431
Weight	(g/m2)		52.6			82.7	-		-
(not multi-part)	(lb)		14			22
Weight	(g/m2)		41.4			56.4
(one sheet of multi-part)	(lb)		11			15
Label Thickness	(inch)		0.0			0.0047
	(mm)		0.0			0.12
Total Thickness	(inch)		0.0025			0.021	-		-
	(mm)		0.065			0.53
Quality (Multi-part forms)		Plain paper, reclaimed		paper, carbonless
		multi-part forms
Quality (Label)		AVERY CONTINUOUS FORM LABELS,
		AVERY MNI-LINE LABELS, or the same
		quality labels
Multi-part binding		∙	Rough bindings of multi-part paper cause paper jam.
		∙	The each sheet of multi-part paper should normally be put
			together by spot-gluing, paper-stapling, tape stitching. Spot-gluing
		∙	is recommended for the better printing quality.
			Spot-gluing must be applied on both sides of paper (Refer to
		∙	Figure 1-7.).
			The spot-glued parts must be pressed flat. There must be no
			creases in the paper.
		∙ The paper-stapling must be applied from the front of paper and the
			paper must be flat (Refer to Figure 1-8.).
		∙ Paper-stapling must be applied for both feeding directions (Refer
			to Figure 1-9.).
		∙ The paper-stapling should be flat (Refer to Figure 1-10.).
		∙ Never use metal staples.
		∙ The position of binding must be outside of printable area.
		∙	Multi-part paper should be bound firmly to each other and the
			binding must not be too large.
Perforation		Refer to Section 1.2.12.5.
Notes		∙	The easy-cone-off label should not be used.
		∙ Every label must be put on the carrier.
		∙ Each comer of those labels must be rounded.
		∙	Each label and backing sheet should not have any folds or
		∙	creases.
			Between each label, there should be the same sheet as those
			labels.
		∙ The backing sheet must be continuous paper.
		∙	Continuous forms with labels should be inserted from front
			entrance.
		Refer to Section 1.2.12.6.

Rev. B 1-15