DFX-8500
3.2.6.20 CR Motor Removal
Step 1: Remove the right cover. (Refer to Section 3.2.3.2.)
Step 2: Disconnect the red and black cables from the terminals on the CR motor. (two cables for each terminal)
Step 3: Remove the three CP(S) (M4x10) screws securing the CR motor to the right side frame and remove the motor.
C P ( S ) ( M 4 X 1
0 )
C R M o t o r
Figure 3-77. CR Motor Removal
ADJUSTMENT REQUIRED
∙When you install the CR motor, perform the carriage timing belt tension adjustment, as described in Section 4.1.2.
∙When you install the printhead, perform the platen gap motor value (platen gap) adjustment, as described in Section 4.1.7.
Rev. B |
