DFX-8500
3.2.4 Circuit Boards Removal
This section describes how to remove the circuit boards.
3.2.4.1 Bottom Panel Assembly Removal
CAUTION
;It is best to remove the top cover before you tilt back the printer as described in the steps below. Refer to Section 3.2.3.1 for instructions on removing the top cover.
;If you tilt back the printer with the top cover attached, be careful not to put too much weight on the top cover or any other printer components.
;Spread a thick, soft cloth under the printer before you follow the steps below.
;When you attach the bottom panel, make sure the parallel interface cable latch is not caught between the lower case and bottom panel.
Step 1: Remove the left and right side covers. (Refer to Section 3.2.3.2)
Step 2: On the right side of the printer mechanism, remove the CBS (O) screw securing the green and yellow earth cable and the earth plate together.
E a r t h C a b le
C B S ( O ) S c r e w ( M 4 x
C 2 0 4 P S B / P S E
B o a r d
B o t t o m P a n e l
A s s e m b ly
( R i g h t s i d e )
Figure 3-23. Connector and Earth Cable Removal (right side)
Rev. B |
