DSP-100/2000
Users Manual
Cable Termination
Because signal reflections can distort the shape of communication signals, the unused ends of cable segments must be terminated to prevent reflections. The terminating device is a resistor with a value equal to the cable’s characteristic impedance. A signal reaching the terminator is neither reflected nor passed: the signal is absorbed and dissipated by the terminating resistance.
Because the test tool relies on signal reflections to determine cable length, the tool cannot measure the length of properly terminated cables.
Interpreting the TDR Plot
The TDR plot has a horizontal scale that represents distance and a vertical scale that represents the percentage of reflection relative to the original signal, as shown in Figure
gc36c.eps
Figure 7-10. A TDR Plot
Notice that the reflection percentages can be positive or negative. A positive value indicates that the polarity of the reflection is the same as the polarity of the original signal. As discussed earlier, positive reflections are caused by abrupt increases in the cable’s impedance, such as those caused by mismatches in cable types, poor connections, or breaks in the cable.
