Fluke DSP-100, DSP-2000 user manual Running the Impulse Noise Test

Running Individual Tests 4

Monitoring Impulse Noise

Running the Impulse Noise Test

The connector type for the noise test is always RJ45. The noise test is not valid for coaxial cable because the level of noise on coaxial cable is negligible.

To monitor impulse noise, refer to Figure 4-6 and proceed as follows:

				RJ45
				Jack	Wall Outlet
	DSP-2000CABLE ANALYZER				2 Meters
					2 Meters
1	2	3	4
TEST			SAVE
FAULT
INFO
EXIT		ENTER			Patch Panel
			WAKE UP
		MONITOR
SINGLE			SETUP
TEST
AUTO			PRINT
TEST
OFF			SPECIAL		DSP-2000SRSMART REMOTE
			FUNCTIONS
			SMART	Test Tool
			REMOTE		PASS
					TESTING
					FAIL
					LOW BATTERY
					Smart
					Remote
					ON
					OFF
					gc24f.eps

Figure 4-6. Connections for Monitoring Impulse Noise (Model DSP-2000 Shown)

4-21