Fluke DSP-2000, DSP-100 user manual Setup Setting, Quick Configuration Settings Description

DSP-100/2000

Users Manual

Quick Configuration

The settings listed in Table 2-3 affect either the display format or the accuracy of your test results. Following the table are instructions for changing the settings. For a complete list of the test tool’s adjustable settings, refer to the later section “Setup.”

SETUP Setting

Test Standard and Cable Type

Average Cable Temperature

Conduit Setting

Remote End

Testing

Length Units

Numeric Format

Display and Report Language

Power Line Noise Filter Frequency

Table 2-3. Quick Configuration Settings

Description

Select the test standard and cable type you are using. Your selection determines which test specifications are used and which tests are run during cable testing. Fiber optic cable testing requires a Fluke DSP Fiber Optic Meter.

Select the cable temperature range that includes the average temperature where the cable is installed. Cable temperature is not applicable to all test standards.

The conduit setting is not applicable to all test standards.

Enables execution of the REMOTE tests. Select Disable or Auto Detect when using a standard remote.

Select meters or feet as the unit for length measurements.

Select a format (0.00 or 0,00) for display of decimal fractions.

Select English, German, French, Spanish, or Italian.

Select the frequency of the ac power in your area. The test tool filters out 50 or 60 Hz noise from measurements.

2-4