Autotest 3

The Autotest Report

Automatically Incrementing the Cable Identification Name

The test tool’s auto increment function increments the last alphanumeric character of the cable identification name each time you save Autotest results.

To enable or disable the auto increment function, proceed as follows:

1.Turn the rotary switch to SETUP.

2.Press $Page Down once.

3.Press ! Choice.

4.Use DUto highlight the status you want.

5.Press Eto select the highlighted status.

If Memory is Full

If the Autotest results you save fill the last available memory location, the following message appears:

WARNING! TEST RESULT MEMORY IS NOW FULL. If you try to save additional test results after the memory has been filled, the following message appears:

UNABLE TO SAVE TEST RESULTS. MEMORY IS FULL.

To save additional test results, you must first delete one or more test reports from memory. You can delete test reports in the SPECIAL FUNCTIONS mode. For complete instructions, see Chapter 5, “Viewing and Printing Saved Reports.”

You can see how many memory spaces are available by pressing the $Memory softkey, which appears on several Autotest displays.

Note

The test tool can store the results from more than 500 Autotests. The exact number of memory spaces available depends on the number of tests run by the selected test standard.

The Autotest Report

Figures 3-9, 3-10, and 3-11 on the following pages show how Autotest results appear in printed reports. You can print Autotest reports or edit the report’s identification information in the PRINT mode. See Chapter 5, “Viewing and Printing Saved Reports,” for complete instructions.

3-25

Page 73
Image 73
Fluke DSP-100, DSP-2000 Autotest Report, Automatically Incrementing the Cable Identification Name, If Memory is Full