DSP-100/2000
Users Manual
Using the Tone Generator (Model DSP-2000)
If you have an inductive pickup device, you can use the test tool’s tone generator to identify cable runs and connections. The tone generator produces a signal on the cable under test. You can hear the signal as an audible tone when you place an inductive pickup device near the cable or one of the cable’s connectors.
To use the tone generator, proceed as follows:
1.Turn the rotary switch to SPECIAL FUNCTIONS.
2.Use a patch cable of the correct impedance to connect the test tool to the CABLE TEST jack.
3.Use Dto highlight Tone Generator; then press E.
4.Use an inductive pickup device along the cable run or at far end connectors to determine which cable is connected to the test tool.
