Calibrations and Custom Test Standards | 6 |
Configuring a Custom Cable |
To configure a custom cable, proceed as follows:
1.Turn the rotary switch to SETUP.
2.Press $Page Down five times.
3.Highlight the custom cable configuration; then press Eto see the menu of custom cable names. The default cable names are
*Custom Cable 1* through *Custom Cable 4*. You can change the cable name after configuring the test parameters. An asterisk always proceeds and follows the name of a custom cable configuration.
4.Use DUto highlight the custom cable name you want to configure; then press E.
5.To select a new baseline test standard, press E. Highlight the desired test standard; then press E.
6.To change the parameters of the test standard shown on Page 1 of 6, use
#Page Up, $Page Down, and DUto highlight the parameter you want to change; then press E.
7.Use the appropriate keys to select the value you want; then press E.
If you selected to change the custom cable name or the cable type, the alphanumeric entry screen appears. Use the appropriate keys to enter a name up to 27 characters long. When you are finished entering characters, press S.
8.Repeat steps 6 and 7 to change additional parameters.
9.When you are finished configuring test parameters, press Sto store the custom configuration.
