WARNING
The Rear Panel at a Glance

1 Slot Identifier (100, 200, 300)

4

Power-Line Fuse-Holder Assembly

2

Ext Trig Input / Alarm Outputs / Channel

5

Power-Line Voltage Setting

 

Advance Input / Channel Closed Output

6

Chassis Ground Screw

3

RS-232 Interface Connector

7

HP-IB (IEEE-488) Interface Connector

Use the Menu to:

∙Select the HP-IB or RS-232 interface (see chapter 2).

∙Set the HP-IB address (see chapter 2).

∙Set the RS-232 baud rate, parity, and flow control mode (see chapter 2).

For protection from electrical shock, the power cord ground must not be defeated. If only a two-contact electrical outlet is available, connect the instrument’s chassis ground screw (see above) to a good earth ground.

5