HP 4200dtnsl, 4300dtns, 4200n, 4200tn manual Devices on

	Message	Explanation or recommended action
	68.X PERMANENT STORAGE	The storage device is failing to write. Printing can continue, but there might be some unexpected
	WRITE FAIL	behaviors because an error occurred in permanent storage.
	To continue press		Press SELECT (	) to continue.
	79.XXXX PRINTER ERROR	The printer detected a critical hardware error.
	To continue turn off then	1.	Press CANCEL JOB to clear the print job from the printer memory. Turn the printer power off,
	on	2.￿	and then turn the printer power on.
			Try printing a job from a different program. If the job prints, go back to the first program and
			try printing a different file. (If the message appears only with a certain program or print job,
			contact the software vendor for assistance.)
		If the message persists with different programs and print jobs, try these steps.
		1.	Disconnect all cables to the printer that connect it to the network or computer.
		2.	Turn the printer power off.
		3.	Remove all memory DIMMs or third-party DIMMs from the printer. (See “Installing memory”
			on page 170.)
		4.	Remove all EIO devices from the printer. (See “Installing EIO cards or mass storage
			devices” on page 173.)
		5.	Turn the printer power on.
		If the error no longer exists, follow these steps.
		1.	Install each DIMM and EIO device one at a time, making sure to turn the printer power off
			and back on as you install each device.
		2.	Replace a DIMM or EIO device if you determine that it causes the error.
		3.	Reconnect all cables that connect the printer to the network or computer.
	8X.YYYY	The EIO accessory in slot [X] has encountered a critical error. [X] description:
	EIO ERROR	1	= EIO slot 1 - The printer detected an error with the EIO accessory.
		2 = EIO slot 2 - The printer detected an error with the EIO accessory.
		6 = EIO slot 1 - The EIO accessory detected an error. The EIO accessory might be defective.
		7 = EIO slot 2 - The EIO accessory detected an error. The EIO accessory might be defective.
		1.	Turn the printer power off, and then turn the printer power on.
		2.	Turn the printer power off, reseat the EIO accessory in slot [X], and then turn the printer
			power on.
		3.	Turn the printer power off, remove the EIO accessory from slot [X], install it in a different
			EIO slot, and then turn the printer power on.
		4.	Replace the EIO accessory in slot [X].
	ACCESS DENIED MENUS LOCKED	The printer control panel function you are trying to use has been locked to prevent unauthorized
		access.
			See your network administrator.
	BAD DUPLEXER CONNECTION	The optional duplexer is not properly connected to the printer.
	For help press	1.	Make sure that you are using the right-angle power cord that came with the printer.
		2.	Try removing and reinstalling the optional duplexer. Then turn the printer power off and
		￿	back on.
	BAD ENV FEEDER CONNECTION	The optional envelope feeder is not connected properly to the printer.
			Try removing and reinstalling the optional envelope feeder. Then, turn the printer power off
			and back on.
	[BINNAME] FULL	The indicated output bin [BINNAME] is full.
	Remove all paper from bin	￿	Empty the bin.
114 4 Problem solving		￿		ENWW