HP 4300dtns, 4200n, 4200dtnsl, 4200tn manual Contacting the HP fraud hotline on

Message	Explanation or recommended action
MANUALLY FEED	1.	Load the requested paper in tray 1. Press SELECT (	) if the correct paper is already
[TYPE] [SIZE]		loaded in tray 1.
alternates with	2.	To have the printer use paper from another tray, press SELECT (		) when tray 1 is empty.
To continue press		The printer will allow you to select a type and size loaded in a different tray.
or
To use another tray press
NON HP CARTRIDGE DETECTED	The printer has detected that the print cartridge is not a genuine HP print cartridge.
For help press		If you believe you purchased an HP print cartridge, call the HP fraud hotline. (See
		“Contacting the HP fraud hotline” on page 145.)
		If a new cartridge has been installed, it might take up to 20 printed pages to correctly verify.
	Note
	￿
	Any printer repair required as a result of using non-HP toner or print cartridges is not covered
	under the printer warranty.
	￿
OPTIONAL BIN 1 FULL	The stacker or stapler/stacker output bin is full.
Remove all paper from bin		Remove the paper stacked in the bin.
ORDER CARTRIDGE	The message first appears when about 15 percent of the toner is remaining in the print cartridge
[XXXX] PAGES LEFT	(at 5 percent coverage, about 1,800 pages remaining for the 12,000-page cartridge in the
For help press	LaserJet 4200 series and about 2,700 pages remaining for the 18,000-page cartridge in the
	LaserJet 4300 series). Depending on how the printer has been configured, it will either continue
	￿
	to print or stop.
	1.	If the printer has stopped, you can resume printing by pressing PAUSE/RESUME for each job.
	2.	You might want to ensure that you have a replacement print cartridge on hand.
	3.	See “Cartridge Low and Cartridge Out conditions” on page 82 for information about how to
		configure printer response to toner messages.
OUTPUT PAPER PATH OPEN	1.	Make sure that the jam-access door on the optional stacker or stapler/stacker is closed.
For help press	2.	If your accessory is a stapler/stacker, make sure that the stapler unit is snapped into the
		closed position.
PAPER WRAPPED AROUND FUSER	1.	Turn the printer power off to keep the paper from wrapping more firmly around the fuser.
For help press	2.	Open the top cover and remove the print cartridge.
alternates with	3.	Remove all visible paper.
Then open and close top	4.	If you cannot locate the paper, leave printer power turned off and remove the fuser to
cover		remove paper. (See “Clearing jams from the fuser area” on page 104.)
	WARNING!
	The fuser is very hot. To avoid minor burns, allow the fuser to cool for 30 minutes before
	removing it from the printer.
PERFORM PRINTER	To ensure optimum print quality, the printer prompts you to perform routine maintenance every
MAINTENANCE	200,000 pages. To order a printer maintenance kit, see “Ordering information” on page 17. For
For help press	information about maintenance, see “Performing preventative maintenance” on page 91.
PROCESSING JOB	The printer is processing the print job.
RAM DISK DEVICE	The RAM disk had a critical failure and can no longer be used.
FAILURE		Contact an HP authorized service or support provider. (See “Ordering parts and supplies”
To enter menus press		on page 143.)
RAM DISK FILE	The requested operation could not be performed. You might have attempted an illegal
OPERATION FAILED	operation, such as trying to download a file to a non existent folder.
To enter menus press	￿

118 4 Problem solving ENWW