HP 4300dtns, 4200n, 4200dtnsl, 4200tn manual Installing EIO cards or mass storage devices

Installing EIO cards or mass storage devices

Follow this procedure to install an EIO card or mass storage device (optional hard disk).

To install EIO cards or mass storage devices

1Turn the printer power off.

2Remove the two screws and cover plate from the EIO 1 or EIO 2 slot on the back of the printer.

3Install the EIO card or mass storage device in the EIO slot and tighten the screws. See the figure below for orientation of the EIO card.

4Turn the printer power on and print a configuration page to verify that the new EIO device is recognized. (See “Configuration page” on page 83.)

Note	For information about connecting an EIO card to a network and installing the network software,
	see “Software for networks” on page 33, the getting started (start) guide that came with the printer,
	and also the HP Jetdirect Print Server Administrator’s Guide.

To remove an installed EIO card or mass storage device (optional hard disk)

1Turn the printer power off.

2Remove the EIO card or mass storage device from the EIO slot.

3Place the cover plate from the EIO 1 or EIO 2 slot onto the back of the printer. Insert and tighten the two screws.

4Turn the printer power on.

Use Device Storage Manager in HP Web Jetadmin to manage fonts on a mass storage device. For more information, see the Help in HP Web Jetadmin.

HP is constantly introducing new software tools for use with your printer and accessories. These tools are available on the Internet free of charge. See “Contacting HP” on page 144 for more information.

ENWW Installing EIO cards or mass storage devices 173