Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch B and the link between Switch A and the MED device on the NMS.
a.Network diagram for basic LLDP configuration
Configuration procedure
Table 61 Configure Switch A
#Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. This step is optional, because LLDP is enabled on Ethernet ports by default.
#Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2.
∙Select Network LLDP from the navigation tree to enter the Port Setup tab, as shown in b. Select port GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 and click Modify Selected. The page shown in c appears.
239