○The number of selected ports that an aggregation group can contain is limited. When the number of candidate selected ports is under the limit, all the candidate selected ports are set to Selected state. When the limit is exceeded, the system selects the candidate selected ports with smaller port IDs as the selected ports, and set other candidate selected ports to Unselected state. At the same time, the peer device, being aware of the changes, changes the state of its ports accordingly.

Table 53 Set the ports that cannot aggregate with the reference port to the Unselected state.

NOTE:

For static and dynamic aggregation modes:

In an aggregation group, the port to be a selected port must be the same as the reference port in port attributes, and class-two configurations. To keep these configurations consistent, you should manually configure the port.

Change a port attribute or class-two configuration setting for a port with caution, because the change may affect the aggregation state of member ports and interrupt services.

Load sharing mode of an aggregation group

Every link aggregation group created on HP V1910 Switch Series operates in load sharing mode all the time, even when it contains only one member port.

Configuring link aggregation and LACP

Configuration task list

Configuring a static aggregation group

Perform the tasks in 1 to configure a static aggregation group.

1.Static aggregation group configuration task list

Task

Remarks

 

Required

 

Create a static aggregate interface and configure member

Creating a link aggregation group

ports for the static aggregation group automatically created

 

by the system when you create the aggregate interface.

 

By default, no link aggregation group exists.

 

 

Displaying information of an aggregate

Optional

Perform this task to view detailed information of an existing

interface

aggregation group.

 

 

 

Configuring a dynamic aggregation group

Perform the tasks in 1 to configure a dynamic aggregation group.

208