HP V1910 manual Configuring Snmp trap function

Item	Description
	Select an SNMP group to which the user belongs.
	∙ When the security level is NoAuth/NoPriv, you can select an
	SNMP group with no authentication no privacy.
Group Name	∙ When the security level is Auth/NoPriv, you can select an
	SNMP group with no authentication no privacy or
	authentication without privacy.
	∙ When the security level is Auth/Priv, you can select an SNMP
	group of any security level.
Authentication Mode	Select an authentication mode (including MD5 and SHA) when the
	security level is Auth/NoPriv or Auth/Priv.
Authentication Password	Set the authentication password when the security level is
	Auth/NoPriv or Auth/Priv.
Confirm Authentication Password	The confirm authentication password must be the same with the
	authentication password.
Privacy Mode	Select a privacy mode (including DES56, AES128, and 3DES)
	when the security level is Auth/Priv.
Privacy Password	Set the privacy password when the security level is Auth/Priv.
	The confirm privacy password must be the same with the privacy
Confirm Privacy Password
	password.
	Associate a basic ACL with the user to restrict the source IP address
	of SNMP packets, that is, you can configure to allow or prohibit
ACL	SNMP packets with a specific source IP address, so as to allow or
	prohibit the specified NMS to access the agent by using this user
	name.

Return to SNMPv3 configuration task list.

Configuring SNMP trap function

Table 38 Select Device  SNMP from the navigation tree. Table 39 Click the Trap tab to enter the page as shown in b.

Table 40 On the upper part of the page, you can select to enable the SNMP trap function; on the lower part of the page, you can configure target hosts of the SNMP traps.

Table 41 Click Add to enter the Add Trap Target Host page, as shown in c.

125