HP V1910 Port isolation group configuration example, Port isolation group configuration items

2.Port isolation group configuration items

Item	Description
	Specify the role of the port or ports in the isolation group.
	∙ Isolate port: Assign the port or ports to the isolation group as an isolated port or
Config type	ports.
	∙ Uplink-port: Assign the port to the isolation group as the uplink port.
	IMPORTANT:
	The uplink port is not supported on HP V1910 Switch Series.
	Select the port(s) you want to assign to the isolation group.
Select port(s)	You can click ports on the chassis front panel for selection; if aggregation interfaces
	are configured, they will be listed under the chassis panel for selection.

Port isolation group configuration example

Network requirements

∙Campus network users Host A, Host B, and Host C are connected to GigabitEthernet 1/0/2, GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4 of Switch.

∙Switch is connected to the Internet through GigabitEthernet 1/0/1.

∙GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4 belong to the same VLAN.

Configure Host A, Host B, and Host C to access the Internet and isolate them from each other.

a.Networking diagram for port isolation group configuration

Internet

GE1/0/2

GE1/0/3

GE1/0/1

Switch

GE1/0/4

Host A Host B Host C

Configuration procedure

#Assign GigabitEthernet 1/0/2, GigabitEthernet 1/0/3, and GigabitEthernet 1/0/4 to an isolation group as isolated ports.

Select Security  Port Isolate Group from the navigation tree and in the page that appears, click the Modify tab to enter the page shown in a.

404