HP V1910 manual For configuring Lldp on the selected port, 243

f.The page for configuring LLDP on the selected port

∙Select Tx from the LLDP Operating Mode drop-down list.

∙Click Apply.

#Enable global LLDP and configure the global LLDP setup as needed (see d). ∙ Click the Global Setup tab.

∙ Select Enable from the LLDP Enable drop-down list. ∙ Click Apply.

Configuration verification

# Display the status information of port GigabitEthernet 1/0/2 on Switch A.

∙Select Network  LLDP from the navigation tree to enter the Port Setup tab.

∙Click GigabitEthernet1/0/2 in the port list.

∙Click the Status Information tab at the lower half of the page. The output shows that port GigabitEthernet 1/0/2 is connected to a non-MED neighbor device (Switch B), as shown in a.

243