a.RADIUS parameter configuration
2. RADIUS parameters
Item | Description | |
| Specify the type of the RADIUS server supported by the device, | |
| including: | |
| ∙ extended: Specifies an extended RADIUS server (usually a | |
| CAMS or iMC server). That is, the RADIUS client and RADIUS | |
Server Type | server communicate using the proprietary RADIUS protocol and | |
packet format. | ||
| ||
| ∙ standard: Specifies a standard RADIUS server. That is, the | |
| RADIUS client and RADIUS server communicate using the | |
| standard RADIUS protocol and packet format defined in RFC | |
| 2138/2139 or later. | |
|
| |
Authentication Server Shared Key | Specify and confirm the shared key for the authentication server. | |
| ||
| These two parameters must have the same values. | |
Confirm Authentication Shared Key | ||
| ||
|
| |
Accounting Server Shared Key | Specify and confirm the shared key for the accounting server. These | |
| ||
Confirm Accounting Shared Key | two parameters must have the same values. | |
| ||
|
| |
| Specify the source IP address for the device to use in RADIUS packets | |
| to be sent to the RADIUS server. It is recommended to use a loopback | |
interface address instead of a physical interface address as the | ||
| source IP address, because if the physical interface is down, the | |
| response packets from the server cannot reach the device. | |
|
| |
Timeout Interval | Set the RADIUS server response timeout. | |
|
|