Description

Use the upgrade server-addresssource-filenamebootrom command to upgrade the Boot ROM image. If the Boot ROM image in the downloaded software package file is not applicable, the original Boot ROM image is still used as the startup configuration file.

Use the upgrade server-addresssource-filenameruntime command to upgrade the system software image file. If the system software image file in the downloaded software package file is not applicable, the original system software image file is still used as the startup configuration file.

To make the downloaded software package file take effect, reboot the device.

NOTE:

The HP V1910 Switch Series does not provide an independent Boot ROM image; instead, it integrates the Boot ROM image with the system software image file together in a software package file with the extension name of .bin.

Examples

#Download software package file main.bin from the TFTP server and use the Boot ROM image in the package as the startup configuration file.

<Sysname> upgrade 192.168.20.41 main.bin bootrom

#Download software package file main.bin from the TFTP server and use the system software image file in the package as the startup configuration file.

<Sysname> upgrade 192.168.20.41 main.bin runtime

Configuration example for upgrading the system software image at the CLI

Network requirements

As shown in a, a V1910 switch is connected to the PC through the console cable, and connected to the gateway through GigabitEthernet 1/0/1. The IP address of the gateway is 192.168.1.1/24, and the TFTP server where the system software image (SwitchV1910.bin) is located is 192.168.10.1/24. The gateway and the switch can reach each other.

The administrator upgrades the Boot ROM image and the system software image file of the V1910 switch through the PC and sets the IP address of the switch to 192.168.1.2/24.

a.Network diagram for upgrading the system software image of the V1910 switch at the CLI

Configuration procedure

Table 13 Run the TFTP server program on the TFTP server, and specify the path of the file to be loaded. (Omitted)

Table 14 Perform the following configurations on the switch.

26