online when the user re-logs into the switching engine before the iMC performs online user detection, and the user cannot get authenticated. In this case, the user can access the network again only when the iMC administrator manually removes the user's online information.

The user re-authentication at restart function is designed to resolve this problem. After this function is enabled, every time the device restarts:

1)The device generates an Accounting-On message, which mainly contains the following information: NAS-ID, NAS-IP-address (source IP address), and session ID.

2)The device sends the Accounting-On message to the IMC at regular intervals.

3)Once the IMC receives the Accounting-On message, it sends a response to the device. At the same time it finds and deletes the original online information of the users who were accessing the network through the device before the restart according to the information (NAS-ID, NAS-IP-address and session ID) contained in the message, and ends the accounting for the users depending on the last accounting update message.

4)Once the device receives the response from the IMC, it stops sending Accounting-On messages.

5)If the device does not receive any response from the IMC after it has tried the configured maximum number of times to send the Accounting-On message, it will not send the Accounting-On message any more.

The device can automatically generate the main attributes (NAS-ID, NAS-IP-address and session ID) contained in Accounting-On messages. However, you can also manually configure the NAS-IP-address with the nas-ipcommand. If you choose to manually configure the attribute, be sure to configure an appropriate valid IP address. If this attribute is not configured, the device will automatically choose the IP address of a VLAN interface as the NAS-IP-address.

Follow these steps to enable the user re-authentication at restart function:

To do…

Use the command…

Remarks

Enter system view

system-view

 

 

 

Enter RADIUS scheme view

radius scheme

radius-scheme-name

 

 

 

 

 

 

 

By default, this function is

 

 

disabled.

Enable the user

accounting-on enable [ send

If you use this command

without any parameter, the

re-authentication at restart

times interval interval ]

system will try at most 15 times

function

 

to send an Accounting-On

 

 

 

 

message at the interval of three

 

 

seconds.

 

 

 

HWTACACS Configuration Task List

Complete the following tasks to configure HWTACACS:

2-19

Page 278
Image 278
3Com WX3000 operation manual Hwtacacs Configuration Task List, Accounting-on enable send, Times interval interval