3Com WX3000 operation manual Dldp Network Example, Reset the Dldp status of a port Dldp reset

To do…	Use the command…	Remarks
Enter system view	system-view
Reset the DLDP status of the system	dldp reset
		Optional
Enter Ethernet port view	interface interface-type
	interface-number
Reset the DLDP status of a port	dldp reset

This command only applies to the ports in DLDP down status.

DLDP Network Example

Network requirements

As shown in Figure 1-3:

z

z

z

Switch A and Switch B are connected through two pairs of fibers. Both of them support DLDP; Suppose the fibers between Switch A and Switch B are connected inversely. DLDP disconnects the unidirectional links after discovering them;

When the network administrator connects the fiber correctly, the ports taken down by DLDP are restored.

Figure 1-3Fiber cross-connection

GE1/0/10 SwitchA GE1/0/11

GE1/0/10 SwitchB GE1/0/11

PC

Configuration procedure

1)Configure Switch A

# Configure the ports to work in mandatory full duplex mode at the speed of 1000 Mbps.

<SwitchA> system-view

[SwitchA] interface gigabitethernet 1/0/10 [SwitchA-GigabitEthernet1/0/10] duplex full

[SwitchA-GigabitEthernet1/0/10] speed 1000

[SwitchA-GigabitEthernet1/0/10] quit [SwitchA] interface gigabitethernet 1/0/11

1-8