3Com WX3000 Network diagram, Configure HWPing Client Switch a # Enable the HWPing client

Network diagram

Figure 1-6Network diagram for the Jitter test

	IP	network
10.1.1.1/8	10.2.2.2/8
Switch A		Switch B
HWPing Client		HWPing Server

Configuration procedure

zConfigure HWPing Server (Switch B):

# Enable the HWPing server and configure the IP address and port to listen on.

<device> system-view

[device] hwping-server enable

[device] hwping-server udpecho 10.2.2.2 9000

zConfigure HWPing Client (Switch A):

# Enable the HWPing client.

<device> system-view

[device] hwping-agent enable

# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "Jitter".

[device] hwping administrator Jitter

# Configure the test type as jitter

[device-hwping-administrator-Jitter] test-type Jitter

# Configure the IP address of the HWPing server as 10.2.2.2.

[device-hwping-administrator-Jitter] destination-ip 10.2.2.2

# Configure the destination port on the HWPing server.

[device-hwping-administrator-Jitter] destination-port 9000

# Configure to make 10 probes per test.

[device-hwping-administrator-http] count 10

# Set the probe timeout time to 30 seconds.

[device-hwping-administrator-Jitter] timeout 30

# Start the test.

[device-hwping-administrator-Jitter] test-enable

# Display test results

[device-hwping-administrator-Jitter] display hwping results administrator Jitter HWPing entry(admin administrator, tag Jitter) test result:

Destination ip address:10.2.2.2
Send operation times: 100	Receive response times: 100
Min/Max/Average Round Trip Time: 9/21/13
Square-Sum of Round Trip Time: 18623
Last complete test time: 2000-4-2 8:14:58.2
Extend result:
SD Maximal delay: 10	DS Maximal delay: 10

1-24