3Com WX3000 operation manual Enabling system information display on the console, Terminal monitor

Table 1-4Default output rules for different output directions

		LOG		TRAP			DEBUG
Output	Modules
		Enable	Severit	Enabled/			Enabled/
direction	allowed
		d/disab			Severity				Severity
			y	disabled			disabled
		led
Console	default (all	Enable	warning	Enabled	debuggin		Enabled		debuggin
	modules)	d	s		g				g
Monitor	default (all	Enable	warning	Enabled	debuggin		Enabled		debuggin
terminal	modules)	d	s		g				g
Log host	default (all	Enable	informati	Enabled	debuggin		Disabled		debuggin
	modules)	d	onal		g				g
Trap buffer	default (all	Disable	informati	Enabled	warnings	Disabled		debuggin
	modules)	d	onal					g
Log buffer	default (all	Enable	warning	Disabled	debuggin		Disabled		debuggin
	modules)	d	s		g				g
SNMP NMS	default (all	Disable	debuggi	Enabled	warnings	Disabled			debuggin
	modules)	d	ng						g

Enabling system information display on the console

After setting to output system information to the console, you need to enable the associated display function to display the output information on the console.

Follow these steps to enable the system information display on the console:

To do…	Use the command…	Remarks
Enable the debugging/log/trap		Optional
information terminal display	terminal monitor
		Enabled by default.
function
Enable debugging information	terminal debugging	Optional
terminal display function		Disabled by default.
Enable log information terminal	terminal logging	Optional
display function		Enabled by default.
Enable trap information	terminal trapping	Optional
terminal display function		Enabled by default.

Make sure that the debugging/log/trap information terminal display function is enabled (use the terminal monitor command) before you enable the corresponding terminal display function by using

the terminal debugging, terminal logging, or terminal trapping command.

1-9