3Com WX3000 Setting to Output System Information to the Trap Buffer, Info-center trapbuffer

To do…	Use the command…	Remarks
	info-center timestamp	Optional
Set the format of the time		By default, the time stamp
	loghost { date no-year-date
stamp to be sent to the log host		format of the information output
	none }	to the log host is date.

Be sure to set the correct IP address when using the info-center loghost command. A loopback IP address will cause an error message prompting that this address is invalid.

Setting to Output System Information to the Trap Buffer

Follow these steps to set to output system information to the trap buffer:

To do…	Use the command…	Remarks
Enter system view	system-view	—
Enable the information center	info-center enable	Optional
		Enabled by default.
		Optional
Enable system information	info-center trapbuffer	By default, the device uses
	[ channel { channel-number	information channel 3 to output
output to the trap buffer	channel-name } size	trap information to the trap
	buffersize ]*	buffer, which can holds up to
		256 items by default.
	info-center source	Optional
Configure the output rules of	{ modu-name default }
	channel { channel-number	Refer to Table 1-4 for the
system information	channel-name } [ { log trap	default output rules of system
	debug } { level severity state	information.
	state } ]*
	info-center timestamp { log	Optional
Set the format of time stamp in		By default, the time stamp
	trap debugging } { boot
the output information		format of the output trap
	date none }
		information is date.

Setting to Output System Information to the Log Buffer

Follow these steps to set to output system information to the log buffer:

To do…	Use the command…	Remarks
Enter system view	system-view	—
Enable the information center	info-center enable	Optional
		Enabled by default.

1-12