3Com WX3000 operation manual Setting to Output System Information to the Console

To do…		Use the command…	Remarks
Set the time	Log host	info-center timestamp
stamp format	direction	loghost date
in the output			Required
direction of
the	Non log host	info-center timestamp { log	Use either command
information	direction	trap debugging } date
center to
date
Set to display the UTC time zone			Required
			By default, no UTC time zone
in the output information of the		info-center timestamp utc
			is displayed in the output
information center
			information

Setting to Output System Information to the Console

Setting to output system information to the console

Follow these steps to set to output system information to the console:

To do…	Use the command…	Remarks
Enter system view	system-view	—
Enable the information center	info-center enable	Optional
		Enabled by default.
		Optional
Enable system information	info-center console channel	By default, the device uses
	{ channel-number	information channel 0 to output
output to the console
	channel-name }	log/debugging/trap information
		to the console.
	info-center source	Optional
Configure the output rules of	{ modu-name default }
	channel { channel-number	Refer to Table 1-4 for the
system information	channel-name } [ { log trap	default output rules of system
	debug } { level severity state	information.
	state } ]*
		Optional
Set the format of time stamp in	info-center timestamp { log	By default, the time stamp
		format of the log and trap
	trap debugging } { boot
the output information		output information is date, and
	date none }
		that of the debugging output
		information is boot.

To view the debugging information of some modules on the device, you need to set the type of the output information to debug when configuring the system information output rules, and use the debugging command to enable debugging for the corresponding modules.

1-8