3Com WX3000 operation manual # Enable Gvrp on GigabitEthernet 1/0/3

[SwitchA-GigabitEthernet1/0/3] port trunk permit vlan all

# Enable GVRP on GigabitEthernet 1/0/3.

[SwitchA-GigabitEthernet1/0/3] gvrp

[SwitchA-GigabitEthernet1/0/3] quit

2)Configure Switch B

# The configuration procedure of Switch B is similar to that of Switch A and is thus omitted.

3)Configure Switch C

#Enable GVRP on Switch C, which is similar to that of Switch A and is thus omitted.

#Create VLAN 5.

[SwitchC] vlan 5

[SwitchC-vlan5] quit

4)Configure Switch D

#Enable GVRP on Switch D, which is similar to that of Switch A and is thus omitted.

#Create VLAN 8.

[SwitchD] vlan 8

[SwitchD-vlan8] quit

5)Configure Switch E

#Enable GVRP on Switch E, which is similar to that of Switch A and is thus omitted.

#Create VLAN 5 and VLAN 7.

[SwitchE] vlan 5

[SwitchE-vlan5] quit

[SwitchE] vlan 7

[SwitchE-vlan7] quit

6)Display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.

# Display the VLAN information dynamically registered on Switch A.

[SwitchA] display vlan dynamic Total 3 dynamic VLAN exist(s). The following dynamic VLANs exist: 5, 7, 8,

# Display the VLAN information dynamically registered on Switch B.

[SwitchB] display vlan dynamic Total 3 dynamic VLAN exist(s). The following dynamic VLANs exist: 5, 7, 8,

# Display the VLAN information dynamically registered on Switch E.

[SwitchE] display vlan dynamic

Total 1 dynamic VLAN exist(s).

The following dynamic VLANs exist:

8

7)Configure GigabitEthernet 1/0/1 on Switch E to operate in fixed GVRP registration mode and display the VLAN information dynamically registered on Switch A, Switch B, and Switch E.

# Configure GigabitEthernet 1/0/1 on Switch E to operate in fixed GVRP registration mode.

[SwitchE] interface GigabitEthernet 1/0/1

1-8