3Com WX3000 Displaying Debugging Status, Displaying Operating Information about Modules in System

You can use the following commands to enable the two settings.

Follow these steps to enable debugging and terminal display for a specific module:

To do…	Use the command…	Remarks
Enable system debugging for	debugging module-name	Required
		Disabled for all modules by
specific module	[ debugging-option ]
		default.
Enable terminal display for	terminal debugging	Required
debugging		Disabled by default.

The output of debugging information affects the system operation. Disable all debugging after you finish the system debugging.

Displaying Debugging Status

Follow these steps to display the current debugging status in the system:

To do…	Use the command…	Remarks
	display debugging [ unit
Display all enabled debugging	unit-id] [ interface	You can execute the display
	interface-type
on the current device		command in any view.
	interface-number ]
	[ module-name ]

Displaying Operating Information about Modules in System

When the device is in trouble, you may need to view a lot of operating information to locate the problem. Each functional module has its corresponding operating information display command(s). You can use the command here to display the current operating information about the modules in the system for troubleshooting your system.

Follow these steps to display the current operation information about the modules in the system:

To do…	Use the command…	Remarks
		You can use this command in
		any view.
Display the current operation	display	You should execute this
information about the modules		command twice to find the
	diagnostic-information
in the system.		difference between the two
		executing results, thus helping
		locate the problem.

2-3