3Com WX3000 operation manual Configuring Gvrp Timers, Garp timer leaveall, Garp timer hold join

Enable GVRP on the port

Configuration procedure

Follow these steps to enable GVRP on an Ethernet port:

To do…	Use the command…		Remarks
Enter system view	system-view	—
Enable GVRP globally	gvrp	Required
		By default, GVRP is disabled globally.
Enter Ethernet port view	interface interface-type		—
	interface-number

gvrp

Required

By default, GVRP is disabled on the port.

After you enable GVRP on a trunk port, you cannot change the port to a different type.

Configuring GVRP Timers

Follow these steps to configure GVRP timers:

	To do…		Use the command…		Remarks
	Enter system view	system-view		—
			garp timer leaveall	Optional
	Configure the LeaveAll timer			By default, the LeaveAll timer is set
			timer-value
				to 1,000 centiseconds.
	Enter Ethernet port view		interface interface-type		—
			interface-number
					Optional
	Configure the Hold, Join, and		garp timer { hold join		By default, the Hold, Join, and Leave
	Leave timers		leave } timer-value		timers are set to 10, 20, and 60
					centiseconds respectively.
Note that:

z

z

The setting of each timer must be a multiple of 5 (in centiseconds).

The timeout ranges of the timers vary depending on the timeout values you set for other timers. If you want to set the timeout time of a timer to a value out of the current range, you can set the timeout time of the associated timer to another value to change the timeout range of this timer.

The following table describes the relations between the timers:

1-5