To do…

 

Use the command…

 

Remarks

 

Enable the function of sending

 

 

 

Optional

 

 

flush enable control-vlan

 

By default, no control VLAN for

 

flush messages in the specified

 

 

 

 

vlan-id

 

sending flush messages is

 

control VLAN

 

 

 

 

 

 

specified.

 

 

 

 

 

 

 

 

 

 

 

Configuring Associated Devices

An associated device mentioned in this document refers to a device that supports Smart Link and locally configured to process flush messages received from the specified control VLAN so as to work with the corresponding Smart Link device. As shown in Figure 1-2, all the devices including Switch C, Switch D, and Switch E on the active and backup links connecting the Smart Link device (Switch A) and the target uplink device (Switch E) are all associated devices.

However, you do not have to enable all the ports of an associated device to process flush messages received from the specified control VLAN. You need to enable this function only on the ports that are on the active and backup links connecting the Smart Link device and the target device. As shown in Figure 1-2, you need to enable this function on GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 of Switch C, GigabitEthernet 1/0/2 and GigabitEthernet 1/0/3 of Switch D, and GigabitEthernet 1/0/11 and GigabitEthernet 1/0/12 of Switch E.

Follow these steps to enable the specified port to process flush messages received from the specified control VLAN:

 

To do…

Use the command…

Remarks

 

Enter system view

system-view

 

 

 

 

 

 

Enable the

System

smart-link flush enable control-vlan vlan-idport

Required, use

 

specified

 

interface-type interface-number [ to interface-type

 

port(s) to

view

either

 

interface-number ]

 

process

 

approach.

 

 

 

 

flush

 

 

By default, no

 

 

 

messages

 

interface interface-type interface-number

control VLAN

 

received

Ethernet

 

for receiving

 

 

from the

port view

smart-link flush enable control-vlan vlan-id

flush messages

 

control

 

is specified.

 

VLAN

 

 

 

 

 

 

 

 

Precautions

When configuring Smart Link, pay attention to the following points:

z

z

z z z

A port or a link aggregation group cannot serve as a member port for two Smart Link groups. On the other hand, a port or a link aggregation group cannot serve as a member for a Smart Link group and a Monitor Link group at the same time.

STP cannot be enabled on the member ports of a Smart Link group. An STP-enabled port or a link aggregation group with an STP-enabled port cannot serve as a member port for a Smart Link group.

A Smart Link/Monitor Link group with members cannot be deleted. Smart Link/Monitor Link is mutually exclusive with remote port mirroring.

When a Combo port operates as a member port of a Smart Link group, the optical port and the electrical port of the Combo port must not be both engaged with a cable at the same time.

1-5

Page 656
Image 656
3Com WX3000 operation manual Configuring Associated Devices, Precautions, Flush enable control-vlan