3Com WX3000 Displaying and Maintaining Protocol-Based Vlan, Display vlan vlan-id to vlan-id all

For the operation of adding a hybrid port to a VLAN in the untagged way (when forwarding a packet, the port removes the VLAN tag of the packet), refer to the section of configuring Ethernet ports in the “Port Basic Configuration” part of this manual.

Displaying and Maintaining Protocol-Based VLAN

To do…	Use the command…	Remarks
Display the information about the	display vlan [ vlan-id[ to vlan-id] all
protocol-based VLAN	dynamic static]
Display the protocol information	display protocol-vlan vlan { vlan-id
and protocol indexes configured		Available in any view
	[ to vlan-id ] all }
on the specified VLAN
Display the protocol information	display protocol-vlan interface
and protocol indexes configured	{ interface-type interface-number [ to
on the specified port	interface-type interface-number ] all }

Protocol-Based VLAN Configuration Example

Network requirements

z

z z

z

As shown in Figure 2-2, Workroom connects to the LAN through port GigabitEthernet 1/0/10 on the switch.

IP network and AppleTalk network workstations (hosts) coexist in the Workroom.

The switch connects to VLAN 100 (using IP network) through GigabitEthernet 1/0/11 and to VLAN 200 (using AppleTalk network) through GigabitEthernet 1/0/12.

Configure the switch to automatically assign the IP and AppleTalk packets to proper VLANs for transmission, so as to ensure the normal communication between the workstations and servers.

Figure 2-2Network diagram for protocol-based VLAN configuration

VLAN 100	VLAN 200
IP Server	Appletalk Server

GEth1 /0/11	GEth1/0/12
	GEth1/0/10

IP Host Appletalk Host

Work room

2-7