FTP Test

Network requirements

As shown in Figure 1-4, both the HWPing client and the FTP server are WX3000 series devices. Perform a HWPing FTP test between the two devices to test the connectivity to the specified FTP server and the time required to upload a file to the server after the connection is established. Both the username and password used to log in to the FTP server are “admin”. The file to be uploaded to the server is cmdtree.txt.

Figure 1-4Network diagram for the FTP test

 

IP

network

10.1.1.1/8

10.2.2.2/8

Switch A

 

Switch B

HWPing Client

 

FTP Server

Configuration procedure

zConfigure FTP Server (Switch B):

Configure FTP server on Switch B. For specific configuration of FTP server, refer to the FTP-SFTP-TFTP part of the manual.

zConfigure HWPing Client (Switch A):

# Configure the IP address for the Ethernet interface.

<device> system-view

[device] interface Vlan-interface 1

[device-Vlan-interface1] ip address 10.1.1.1 8

# Enable the HWPing client.

[device] hwping-agent enable

# Create a HWPing test group, setting the administrator name to "administrator" and test tag to "FTP".

[device] hwping administrator ftp

# Configure the test type as ftp.

[device-hwping-administrator-ftp] test-type ftp

# Configure the IP address of the FTP server as 10.2.2.2.

[device-hwping-administrator-ftp] destination-ip 10.2.2.2

# Configure the FTP login username.

[device-hwping-administrator-ftp] username admin

# Configure the FTP login password.

[device-hwping-administrator-ftp] password admin

# Configure the type of FTP operation.

[device-hwping-administrator-ftp] ftp-operation put

# Configure a file name for the FTP operation.

[device-hwping-administrator-ftp] filename cmdtree.txt

# Configure to make 10 probes per test.

1-20

Page 631
Image 631
3Com WX3000 operation manual FTP Test