configuration command once on one port and that configuration will apply to all ports in the port group. This effectively reduces redundant configurations.

A Port group could be manually created by users. Multiple Ethernet ports can be added to the same port group but one Ethernet port can only be added to one port group.

Follow these steps to configure a port group:

 

 

To do…

 

Use the command…

 

Remarks

 

 

 

Enter system view

 

system-view

 

 

 

 

 

 

 

 

 

 

 

 

Create a port group or enter the specified port

 

port-group group-id

 

Required

 

 

 

group view

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Add an Ethernet port to a specified port group

 

port interface-list

 

Required

 

 

 

 

 

 

 

 

 

A port can not be added to a port group if it has been added to an aggregation group, and vice versa.

Setting Loopback Detection for an Ethernet Port

Loopback detection is used to monitor if loopback occurs on a port.

After you enable loopback detection on Ethernet ports, the device can monitor if external loopback occurs on them. If there is a loopback port found, the device will put it under control.

z

z

If loopback is found on an access port, the system disables the port, sends a Trap message to the client and removes the corresponding MAC forwarding entry.

If loopback is found on a trunk or hybrid port, the system sends a Trap message to the client. When the loopback port control function is enabled on these ports, the system disables the port, sends a Trap message to the client and removes the corresponding MAC forwarding entry.

Follow these steps to set loopback detection for an Ethernet port:

 

To do…

 

Use the command…

 

Remarks

 

Enter system view

 

system-view

 

 

 

 

 

 

 

 

Enable loopback detection

 

 

 

Required

 

 

loopback-detection enable

 

By default, loopback detection

 

globally

 

 

 

 

 

 

is disabled globally.

 

 

 

 

 

 

 

 

 

 

 

 

Set time interval for port

 

loopback-detection

 

Optional

 

 

 

The default interval is 30

 

loopback detection

 

interval-time time

 

 

 

 

seconds.

 

 

 

 

 

 

 

 

 

 

 

 

Enter Ethernet port view

 

interface interface-type

 

 

 

interface-number

 

 

 

 

 

 

 

 

 

 

 

 

 

Enable loopback detection on a

 

 

 

Required

 

 

loopback-detection enable

 

By default, port loopback

 

specified port

 

 

 

detection is disabled.

 

 

 

 

 

 

 

 

 

 

 

 

Enable loopback port control on

 

loopback-detection control

 

Optional

 

 

 

By default, loopback port

 

the trunk or hybrid port

 

enable

 

 

 

 

control is not enabled.

 

 

 

 

 

 

 

 

 

 

 

 

1-9

 

 

Page 116
Image 116
3Com WX3000 operation manual Setting Loopback Detection for an Ethernet Port