3Com WX3000 operation manual Information Center Configuration

You can use the sysname command to modify the system name. Refer to the System Maintenance and Debugging part of this manual for details)

Note that there is a space between the sysname and module fields.

Module

The module field represents the name of the module that generates system information. You can enter the info-center source ? command in system view to view the module list. Refer to Table 1-3 for module name and description.

Between “module” and “level” is a “/”.

Level (Severity)

System information can be divided into eight levels based on its severity, from 1 to 8. Refer to Table 1-1 for definition and description of these severity levels. Note that there is a forward slash “/” between the level (severity) and digest fields.

Digest

The digest field is a string of up to 32 characters, outlining the system information.

Note that there is a colon between the digest and content fields.

Content

This field provides the content of the system information.

The above section describes the log information format sent to a log host by the device. Some log host software will resolve the received information as well as its format, so that you may see the log format displayed on the log host is different from the one described in this manual.

Information Center Configuration

Introduction to the Information Center Configuration Tasks

Complete the following tasks to configure the information center:

Task	Remarks
Configuring Synchronous Information Output	Optional
Configuring to Display the Time Stamp with the UTC Time Zone	Optional
Setting to Output System Information to the Console	Optional
Setting to Output System Information to a Monitor Terminal	Optional
Setting to Output System Information to a Log Host	Optional
Setting to Output System Information to the Trap Buffer	Optional
Setting to Output System Information to the Log Buffer	Optional
1-6