Disable inventory update
Disables inventory update allowing doors to be opened and closed
without performing inventory update. (See “Disable Inventory
Update” on page 176.)
Enable inventory update
Enables inventory update to take place whenever the library system
is returned to Auto/Online mode after an enclosure door is opened
and closed. (See “Enable Inventory Update” on page177.)
Perform inventory update (Full)
Performs an immediate inventory update. This option is only
available if the library system is in Auto mode and Online state.
(See “Perform Inventory Update (Full)” on page177.)
Perform inventory update (Partial)
Performs inventory on just the frames on which the doors have
been opened. This option is only available if the library system is in
Auto mode and Online state. (See “Perform Inventory Update
(Partial)” on page 179.)
Stand-alone drive
Allows the selection of the following:
Setup stand-alone drive
Set up special stand-alone library functions. (See “Stand-Alone
Device” on page 180.)
Reset stand-alone drive
Reset stand-alone drives. (See “Reset Stand-Alone Device” on
page 182.)
Stand-alone drive status
Provides status for stand-alone drives. (See “Stand-Alone Device
Status” on page 183.)
Insert unlabeled cartridges
Display the Insert Unlabeled Cartridge pop-up window that allows the
operator to insert unlabeled cartridges into the library. (See “Insert
Unlabeled Cartridges” on page 184.)
LAN Options
Allows the selection of the following:
Add LAN host
(See “Add LAN Host” on page185)
Delete LAN host
(See “Delete LAN Host” on page190)
Update LAN host information
(See “Update LAN Host Information” on page191)
LM LAN information
(See “LM LAN Information” on page198)
Operator intervention
Display the intervention-required conditions. Youcan specify the items
where action was taken. (See “Operator Intervention” on page199.)
154 Magstar 3494 TapeLibrary Operator Guide