2.On the Insert Cartridges screen (see Figure 144), enter the volser of the cartridge to be inserted. The cartridge volser is the set of up to six alphanumeric characters on the label attached to the end of the cartridge.

Note: Use the left and right arrow key to move the cursor within a ®eld. Use the Tab key to move between ®elds.

3.Type the character (I,E or J) that corresponds to the cartridge type.

Note:

vCartridge System Tape (single-tone case) is type 1.

vEnhanced Capacity Cartridge System Tape (two-tone case) is type E.

vHigh Performance Cartridge Tape (black with blue tabs) is type J.

4. Type the character (0, 1, or 2) that corresponds to the library to associate the

cartridge with. The selections are:

v

0.

Non-VTS Library

v

1.

VTS 1

v

2.

VTS 2

The associated library sequence number is displayed next to each selection.

Note: Only J type media can be inserted into a Virtual Tape Server logical

 

 

library.

The function keys for the pop-up window are:

Insert Cartridges

Complete the cartridge information, then press the Enter key.

Volser of Cartridge. . .

WCC001

 

Cartridge type

_1.

Cartridge System Tape

 

E.

Enhanced Capacity Cartridge System Tape

 

J.

High Performance Cartridge Tape

Library

_0.

Non-VTS Library - xxxxx

 

1.

VTS 1

- xxxxx

 

2.

VTS 2

- xxxxx

F1=Help F3=HideScreen F12=Cancel

 

Figure 144. Manual Mode Insert Cartridges Screen

F1

Display the help information for this screen.

F3

Hides this pop-up window (Manual Mode Terminal). The Manual Mode

 

Terminal pop-up window is hidden but can be retrieved by selecting the

 

Mode pull-down and then selecting Manual mode.

F12

Close this screen and return to the Action List screen.

Arrows

 

 

Move the cursor by pressing the right or left arrow key.

Enter

Con®rm entries in a ®eld or con®rm the insertion of a cartridge.

Chapter 6. Advanced Operating Procedures 233

Page 255
Image 255
IBM Magstar 3494 manual F12, Enter