IBM Magstar 3494 manual Starting Snmp, Stopping Snmp

Figure 137. SNMP Con®guration Pop-Up Window

Adding a Destination::

1.Once the HRMCNFIG program is running, select the trap destination radio button. The Network Mask input ®eld will then be grayed out. (SNMP trap messages do not need to use this option.)

2.Select UDP in the Protocol ®eld, enter the monitor station name and address in the appropriate ®elds, and selectAdd. Do this for each of the monitor stations.

3.Select OK when done.

Note: HRMCNFIG is an external process to the Library Manager, and therefore, the user must wait until that process has completed before Library Managers SNMP support is enabled. To do this, wait until the Change SNMP trap destinations becomes selectable again (ungrayed). Once it has become selectable, all SNMP features can be used.

Deleting a Destination::

1.Highlight the SNMP trap destination that you want to delete in the list box.

2.Select the Delete push-button.

3.Select OK when done.

Starting SNMP

Once the trap types have been selected and the SNMP trap destinations con®gured, the Library Manger SNMP support needs to be enabled. To do this, select Start SNMP from the SNMP options menu.

Selecting this menu item starts the SNMP daemon. To ensure that the daemon is running, use Ctrl + Esc to bring up a window list, and make sure that SNMPD is listed.

Stopping SNMP

Selecting the Stop SNMP sub-menu item under the SNMP Options menu item will disable the Library Manager's SNMP features. No Library Manager SNMP traps will be generated if the SNMP daemon is not running.

212Magstar 3494 Tape Library Operator Guide