IBM Magstar 3494 manual Reviewing Unknown Volume Locations

2.Go to the drive or storage cell and remove the cartridge. Verify that the cartridge volser matches the volser speci®ed on the action list.

Notes:

a.If the From location is a drive, remove the cartridge from the drive.

b.If the From location is followed by ?, the cartridge has already been used in Manual mode. If the cartridge is not present in the indicated From location, look in the location where you are storing demounted cartridges, for example, the high-capacity output area.

3.Remove the cartridge from the enclosure or place it in a safe location. Be sure to remove all ejected cartridges from the enclosure when Manual mode operations are completed.

4.Con®rm that the eject is complete as follows:

a.Highlight the action item to be con®rmed on the Action List screen of the library manager.

To highlight an item, use the up and down arrow keys to move the highlight bar to the desired action item.

b.Con®rm the highlighted action item by pressing the Enter key.

Note: Be sure to con®rm each ejected cartridge after completing the eject task. Eject actions remain on the Action List screen until they are manually con®rmed.

5. Press the Refresh key (F9) to update the list.

Reviewing Unknown Volume Locations

Use this procedure if you are not sure where a volume should go. You can display the volser From location and To location of the last 20 completed actions. Use this information to verify the accuracy of a completed action item.

1.Press the Review key (F6) on the Action List screen of the library manager. See Figure 143 on page 230.

2.Return to the Action List screen by pressing F12.

If the volume was not listed on the Review List screen (see Figure 146 on

page 236), use the Locate Cartridge Home screen to ®nd a storage cell in which to put the volume. See Figure 148 on page 238.

Chapter 6. Advanced Operating Procedures 235