IBM Magstar 3494 manual Import and Export Messages from Library, Bytes 0±4

Table 42. Status Codes and Status Text	(continued)
Operation Status		Resolution Actions
Status Code		For each logical volume having this Status Code, the
		tape management system database must be searched
32
		and corrected if a 'container volume' is shown.
Status Text		For DFSMSrmm, the following steps may be taken:
Invalid container volume
Probable Cause		1. Using the volser of the ®rst volume in the Status File
		with Status Code X©32©, perform a RMM
For Export, a cancel issued by an operator from
		LISTVOLUME and determine if a container volume is
the Library Manager console or a termination
		shown. If none is found, proceed with RMM
due to host inactivity may have resulted in a
		LISTVOLUME for all volumes with Status Code X©32©
'container volume' being shown in the tape
		until a container is identi®ed.
management system database for logical
		2. If RMM LISTVOLUME has been performed for all
volumes which have not been exported from the
		logical volumes with Status Code X©32© and a
VTS.
		container volume has not been found, then further
		action is not necessary.
		3. For those logical volumes with Status Code X©32©
		which are found to have a container volume, it is
		necessary to change the container volume to
		blanks.
		4. Using the volser identi®ed as the container volume,
		search for volumes associated with the container
		volume and build RMM CHANGEVOLUME
		commands for each volume. Use the command:
		RMM SEARCHVOLUME VOLUME(*) OWNER(*) LIMIT(*)
		CONTAINER(container_volser)
		CLIST(©RMM CV©,© CONTAINER(" ") FORCE©)
		5. Run the CLIST created in step 4 to perform the
		change to a blank container volume for all volumes
		found with the identi®ed container volume.
		Alternatively, each logical volume with Status Code X©32©
		which has a container volume may be changed to a blank
		container without building a CLIST. After using RMM
		LISTVOLUME to ®nd logical volumes with a container
		volume, user the command:
		RMM CHANGEVOLUME volser CONTAINER(© ©) FORCE
		Note: Tape management systems other than
		DFSMSrmm must facilitate a function to search and
		change the container volume ®eld to blanks for logical
		volumes with a Status Code X©32© in the Status File upon
		completion of the Export operation.

Import and Export Messages from Library

During processing of an Export or Import operation, the VTS subsystem generates status messages that indicate the progress of the operation. The message is broadcast to all hosts attached to the VTS subsystem. On MVS hosts, the message results in a console message being written in the following format:

CBR3750I MESSAGE FROM LIBRARY <library-name>: 70 EBCDIC character message

The 70 character message contains the status message as de®ned below:

Bytes 0±4

Unique Message Code The unique message code is further de®ned as a

326Magstar 3494 Tape Library Operator Guide