IBM Magstar 3494 manual Mislabeled cleaner cartridge has been left in device

Table 21. Intervention Required Conditions relating to cleaner cartridges (continued)

Intervention Required Condition	Resolution Actions
Message	1.	Place the library system in pause mode.
A mislabeled cleaner cartridge has been left in device	2.	Open the appropriate enclosure door.
xxx feed slot. Remove the cartridge.	3.	If the cartridge is accessible, remove it.
Probable Cause	4.	If the cartridge is in a 3490 device, make the device
		not ready by pressing the Ready switch, press the
During a clean operation, tape device xxx determined that		Unload switch to unload the cartridge, remove the
		cartridge, then make the device ready by pressing
the cleaner cartridge is not compatible with the device but
		the Ready switch.
was not able to unload the cartridge. It is likely that the
	5.	If the cartridge is in a 3590 device, select Unload
cartridge has a missing or damaged media type label or
the media type label is incorrect for the cartridge media		from the Options Menu and press Enter. Remove
type.		the cartridge.
	6.	If unable to remove cartridge, call your service
		representative.
	7.	Close the enclosure door.
	8.	Place the library system in auto mode.
	9.	Inspect the cartridge's seventh character. Install the
		correct seventh character representing the media
		type. See the tape drive Operator's Guide for the
		procedure.
	10.	Place the cartridge in the convenience I/O station.

Table for Intervention Conditions of a Library Virtual Tape Server

Table 22. Intervention Required Conditions relating to a Virtual Tape Server in the Library

Intervention Required Condition	Resolution Actions
Message	1. Notify your system administrator.
Logical volume xxxxxx was not fully recovered from
damaged stacked volume yyyyyy. (VTS z)
Probable Cause
During the attempted movement of logical volume xxxxxx
from a damaged stacked volume which is in Read-only
mode, a permanent read error was encountered. The
error was not recoverable. The data associated with the
logical volume was not recovered, and was not moved to
another stacked volume.

Chapter 8. Problem Determination Procedures 295