Liebert Universal Monitor user manual Setup Menu, See Description

Setup Menu

Setup Menu

This section presents Service Terminal Interface screens for each of the following:

Setup Menu

SETUP MENU

1=SETUP INPUT 2=SETUP COMMON ALARM 3=SETUP SENSOR 4=SETUP I/O MATRIX 5=SETUP OUTPUT 6=SETUP MODEM&PAGERS 7=SETUP SYSTEM INFORMATION* 8=SETUP EXPANSION BOARD 9=OVERRIDE OUTPUT

0=CLEAR ALARMS&LOGS

I=RETURN TO MAIN MENU SELECT A NUMBER:

See: Description

Section A.6.1 Configure digital inputs

Section A.6.2 Set up the common alarm to reset with silence Section A.6.3 Configure analog inputs

Section A.6.4 Set up mapping for inputs to trigger actions in outputs Section A.6.5 Configure digital outputs

Section A.6.6 Configure modem and up to four pager numbers Section A.6.7 Set up features such as password and date & time* Section A.6.8 Specify the Expansion Board as connected Section A.6.9 Manually override automatic control of outputs Section A.6.10 Clear active alarms; clear alarm, event and trend logs

*Setup System Information features are:

•Change Password

•Change Date & Time/Automatic Daylight Saving Time

•Setup Site ID

•Connect Battery

•Backup and Upload Configuration File (Service Terminal Interface only)

•Setup Service Phone Number

•Factory Defaults

•Firmware Update (Service Terminal Interface only)

•Initiate Remote Alarm Test (Service Terminal Interface only)

Note that three of these system features—Backup and Upload Configuration File, Firm- ware Update and Initiate Remote Alarm Test—are unique to the Service Terminal Interface.

Tips on Using the Service Terminal Interface

Use the following tips when making changes in the Service Terminal Interface:

•Data that can be entered is shown in parentheses ( ) in prompt line.

•The current setting is shown in brackets [ ] in the line below the prompt

•To accept the current setting, press the Enter key.

•To change the current setting, enter the value and then press Enter.

•Pressing Escape will exit the current setup function or take you to the previous menu screen.

Current setting shown in brackets [ ]

>CHANGE LABEL(8 CHARACTERS MAX). >[INPUT_01]

>[

>COMMAND SUCCESSFUL

>IS INPUT NORMALLY OPENED(NO) OR NORMALLY CLOSED(NC)? >[NO]

>[

>COMMAND SUCCESSFUL

Values that may be entered shown in parentheses ( )

105