Liebert Universal Monitor user manual Map Input to Expansion Board Output, MAP To EXP Board

System and Control Options

Map Input to Expansion Board Output

•From the Select Outputs menu, select Map to Exp Board if you want to map the selected input to an output on the optional Expan- sion Board. These outputs are identified as Outputs 9-16.

•On the Output Map screen, you may map the selected input to any of the eight outputs (9-16)—or to more than one output, if desired. The example at right shows Input_01 mapped to Output10.

To make changes to the mapping:

•If needed, press Enter ↵ to advance to the position directly below the output.

•Use the arrows ↑ ↓to choose Y (Yes - Mapped to this output) or N (No - Not mapped), then press Enter ↵ .

•Press Enter ↵ to advance to the next position where you want to make a change.

Select Outputs

SELECT OUTPUTS

MAP	TO MAIN BOARD
> MAP	TO EXP BOARD
↑ ↓=NEXT		↵ =SELECT

Output Map

1 OUTPUT MAP

0910111213141516 N Y N N N N N N

↑↓=Y/N ↵ =NEXT/END

•Use the arrows ↑ ↓to choose Y (Yes - Mapped to this output) or N (No - Not mapped), then press Enter ↵ .

•When finished, press Enter ↵ again.

Default Mappings - Digital Inputs to Outputs

Table 23 shows the default mapping of digital inputs to digital outputs.

Table 23 Default mapping of digital inputs to digital outputs

Digital input	By default, mapped to digital output:
Input_01	Output01
Input_02	Output02
Input_03	Output03
Input_04	Output04
Input_05	Output05
Input_06	Output06
Input_07	Output07
Input_08	Output08

NOTE: By default, no Expansion Board inputs are mapped to any outputs.

56