System and Control Options
9.6.2Set Up Mapping for an Analog Sensor Input
•Use the arrows ↑ ↓to choose Map Sensor To Outpt from the Map Input/Sensor Menu, and press Enter ↵ .
•From the Select Sensor Menu, choose the input you
Map Sensor to Main Board Output
•From the Select Outputs menu, select Map to Main Board if you want to map the selected sensor to an output on the Universal Monitor main board. These outputs are identified as Outputs
•On the Output Map screen, you may map the selected sensor to any of the eight outputs
To make changes to the mapping:
•If needed, press Enter ↵ to advance to the position directly below the output.
•Use the arrows ↑ ↓to choose Y (Yes - Mapped to this output) or N (No - Not mapped), then press Enter ↵ .
•Press Enter ↵ to advance to the next position where you want to make a change.
•Use the arrows ↑ ↓to choose Y (Yes - Mapped to this output) or N (No - Not mapped), then press Enter ↵ .
•When finished, press Enter ↵ again.
Map Sensor to Expansion Board Output
•From the Select Outputs menu, select Map to Exp Board if you want to map the selected sensor to an output on the optional Expansion Board. These outputs are identified as Outputs
•On the Output Map screen, you may map the selected sensor to any of the eight outputs
To make changes to the mapping:
•If needed, press Enter ↵ to advance to the position directly below the output.
•Use the arrows ↑ ↓to choose Y (Yes - Mapped to this output) or N (No - Not mapped), then press Enter ↵ .
•Press Enter ↵ to advance to the next position where you want to make a change.
•Use the arrows ↑ ↓to choose Y (Yes - Mapped to this output) or N (No - Not mapped), then press Enter ↵ .
•When finished, press Enter ↵ again.
Map Input/Sensor Menu
MAP INPUT TO OUTPUT
> MAP SENSOR TO OUTPT
↑ ↓=NEXT ↵ =SELECT
Select Sensor
SELECT SENSOR
> SENSOR_1 HIGH STPT
SENSOR_1 LOW STPT | |
↑ ↓=NEXT | ↵ =SELECT |
SENSOR_2 HIGH STPT SENSOR_2 LOW STPT SENSOR_3 HIGH STPT SENSOR_3 LOW STPT SENSOR_4 HIGH STPT SENSOR_4 LOW STPT
Select Outputs
SELECT OUTPUTS
>MAP TO MAIN BOARD MAP TO EXP BOARD
↵=SELECT↑ ↓=NEXT
Output Map
1H OUTPUT | MAP |
| |||
1 2 3 | 4 | 5 | 6 | 7 | 8 |
N N N | Y | N | N | N N | |
↑↓=Y/N ↵ =NEXT/END
Select Outputs
SELECT OUTPUTS MAP TO MAIN BOARD
> MAP TO EXP BOARD | |
↑ ↓=NEXT | ↵ =SELECT |
Output Map
1H OUTPUT MAP
0910111213141516 N N Y N N N N N
↑↓=Y/N ↵ =NEXT/END
Default Mappings - Analog Inputs to Outputs
By default, analog inputs are not mapped to any digital output, as shown in Table 24.
Table 24 Default mapping of analog inputs to digital outputs
Analog input | By default, mapped to digital output: |
|
|
Sensor_1 | (none) |
|
|
Sensor_2 | (none) |
|
|
Sensor_3 | (none) |
|
|
Sensor_4 | (none) |
|
|
57
