System and Control Options
Enable Modem Diagnostic Messages
Enabling modem diagnostics will provide the following additional information about the modem to the computer using the Service Terminal Interface:
No carrier Busy
No answer
Pager checksum error Pager pin number error
Error (indicates incorrect phone number, dial prefix or modem initialization string)
For alphanumeric pager failures:
Paging company non answer on 1st
Paging company non answer on 2nd
Paging company non answer on Last
Paging company non answer on Handshake
•At the Enable Modem Diagnostic Messages prompt, enter Y (Yes - enable) or N (No - disable). The current setting appears in
>ENABLE MODEM DIAGNOSTIC
>[
>COMMAND SUCCESSFUL
•Press Enter to proceed, or Escape to cancel the entry. If you make a change, a confirmation mes- sage appears: “Command Successful.”
Change Modem Dial Prefix
•At the Change Modem Dial Prefix prompt, enter the prefix to be dialed. The current setting appears in
>CHANGE MODEM DIAL PREFIX. >[ATE0X4DT]
>[
>COMMAND SUCCESSFUL
•For international dialing involving countries that do not support B5 (see Table 28), add country codes to the initialization string using the format +GCI=xx, where xx is the country code. (Note: Also requires MT5600SMI modem; model number is on modem label.)
See 9.8.1 - Modem Setup - Initialization String for more information.
•Press Enter to proceed, or Escape to cancel the entry. If you make a change, a confirmation mes- sage appears: “Command Successful.”
Change Modem Hang Up Delay After a Call
•At the Change Modem Hang Up Delay After a Call prompt, enter the number of seconds to delay hanging up after a call. The maximum is 99 seconds. The current setting appears in brackets— [10] in the following example.
>CHANGE MODEM HANG UP DELAY AFTER A CALL(99 SEC MAX). >[10] >[
>COMMAND SUCCESSFUL
•Press Enter to proceed, or Escape to cancel the entry. If you make a change, a confirmation mes- sage appears: “Command Successful.”
63
