System and Control Options
9.8Setup System - Setup Modem & Pagers
To use the modem and pager features, be sure to connect the phone line connector to a telephone wall jack using an RJ11 cord, as described in 4.6.2 - Phone Line Connector.
9.8.1Modem Setup - Initialization String
The Universal Monitor has an
Supported Modem Settings
Supported settings vary for different types of access:
Table 26 Supported modem settings
For: | Modem supports: |
|
|
9600 baud, no parity, 8 data bits, 1 stop bit | |
|
|
Pager access | 9600 baud, even parity, 7 data bits, 1 stop bit and TAPI protocol version 1.8 |
|
|
| For calls involving countries that do not support country code B5 (see Table 28): |
International | • Modem model MT5600SMI is required (model number is on the modem label). |
dialing | • +GCI=xx (xx is the country code) must be added to the initialization string (see Step 7 in |
| this section). |
Default Modem Settings
Table 27 shows the default settings for modem options.
Table 27 Default settings - modem
Feature | Default | Other Options |
|
|
|
|
| Any string (up to 40 characters); for international dialing, |
Initialization String (Init String) | ATS0=1 | add +GCI=xx, where xx is the country code (except B5 |
|
| |
Enable Modem Diagnostic Messages | N (disable) | Y (enable) |
|
|
|
Modem Dial Prefix | ATE0X4DT | Any string |
|
|
|
Modem Hang Up Delay After a Call | 10 seconds | Any number (up to 99 seconds) |
|
|
|
Configuring the Modem
To configure the modem:
Log In and Choose Setup System
1.From the Main Menu, use the arrows ↑ ↓ to choose System and Control, then press Enter ↵ (see 9.1 - Login for help).
2.Enter your password at the Login screen.
3.From the System and Control Menu, use the arrows ↑ ↓ to choose Setup System, then press Enter ↵ .
Setup System Menu
SETUP INPUT
SETUP COMMON ALARM SETUP SENSOR SETUP I/O MATRIX
↑↓=NEXT ↵ =SELECT
SETUP OUTPUT
>SETUP MODEM&PAGERS SETUP SYSTEM INFO SETUP EXP BOARD
60
